2023 Mitsubishi Outlander Sport

small SUV / 4-door SUV

2023 Mitsubishi Outlander Sport 4-door SUV
2018 Mitsubishi Outlander Sport shown

Crashworthiness

Rating overview
Small overlap front: driver-side
Moderate overlap front: original test
Side: original test
Roof strength
Head restraints & seats

Crash avoidance & mitigation

Front crash prevention: vehicle-to-vehicle
Standard system
Superior

Seat belts & child restraints

LATCH ease of use

Key

  • G
    Good
  • A
    Acceptable
  • M
    Marginal
  • P
    Poor
  • Superior
  • Advanced
  • Basic

Some ratings use a scale of Poor to Good. Others range from Basic to Superior.

Small overlap front: driver-side

Rating applies to 2011-24 models

Tested vehicle: 2012 Mitsubishi Outlander Sport SE 4-door 4wd

The Mitsubishi Outlander Sport was introduced in the 2011 model year.

Overall evaluation
Structure and safety cage
Driver injury measures
Head/neck
Chest
Hip/thigh
Lower leg/foot
Driver restraints and dummy kinematics
The dummy’s head contacted the frontal airbag but slid off the left side, leaving the head vulnerable to contact with forward side structure. The side curtain airbag deployed but does not have sufficient forward coverage to protect the head from contact with forward side structure and outside objects. The side torso airbag also deployed.

Action shot taken during the driver-side small overlap frontal crash test.

The dummy's position in relation to the door frame, steering wheel, and instrument panel after the crash test indicates that the driver's survival space was maintained reasonably well.

The dummy’s head contacted the frontal airbag but then slid off the left side. The side curtain airbag did not extend quite far enough forward toward the A-pillar to protect the head from contact with forward side structure.

Except for door hinge pillar deformation, intrusion into the driver's space was reasonably well controlled, and risk of injuries to the dummy's legs and feet was low.

Technical measurements for this test

Measures of occupant compartment intrusion on driver side

Test ID CEN1227
Lower occupant compartment
Lower hinge pillar max (cm) 15
Footrest (cm) 11
Left toepan (cm) 8
Brake pedal (cm) 6
Parking brake (cm) 0
Rocker panel lateral average (cm) 5
Upper occupant compartment
Steering column 1
Upper hinge pillar max (cm) 13
Upper dash (cm) 12
Lower instrument panel (cm) 11

Driver injury measures

Test ID CEN1227
Head
HIC-15 84
Peak gs at hard contact no contact
Neck
Tension (kN) 1.2
Extension bending moment (Nm) 7
Maximum Nij 0.20
Chest maximum compression (mm) 28
Femur (kN)
Left 3.4
Right 0.9
Knee displacement (mm)
Left 9
Right 1
Knee-thigh-hip injury risk (%)
Left 1
Right 0
Maximum tibia index
Left 0.68
Right 0.36
Tibia axial force (kN)
Left 1.9
Right 1.9
Foot acceleration (g)
Left 61
Right 53

How the driver-side small overlap front test is conducted

Moderate overlap front: original test

Rating applies to 2011-24 models

Tested vehicle: 2011 Mitsubishi Outlander Sport SE 4-door 4wd

The Mitsubishi Outlander Sport was introduced in the 2011 model year. The vehicle is a variant of the Outlander SUV with a shorter overall length and no availability of a V6 engine or third row seats. Frontal ratings are assigned by the Institute based on a test conducted by Mitsubishi as part of frontal crash test verification.

Overall evaluation
Structure and safety cage
Driver injury measures
Head/neck
Chest
Leg/foot, left
Leg/foot, right
Driver restraints and dummy kinematics
Technical measurements for this test

Measures of occupant compartment intrusion on driver side

Test ID VTF1008
Footwell intrusion
Footrest (cm) 4
Left (cm) 10
Center (cm) 10
Right (cm) 7
Brake pedal (cm) 12
Instrument panel rearward movement
Left (cm) 0
Right (cm) 1
Steering column movement
Upward (cm) 0
Rearward (cm) 0
A-pillar rearward movement (cm) 0

Driver injury measures

Test ID VTF1008
Head
HIC-15 207
Peak gs at hard contact 35
Neck
Tension (kN) 1.5
Extension bending moment (Nm) 12
Maximum Nij 0.23
Chest maximum compression (mm) 34
Legs
Femur force - left (kN) 1.6
Femur force - right (kN) 2.5
Knee displacement - left (mm) 1
Knee displacement - right (mm) 2
Maximum tibia index - left 0.46
Maximum tibia index - right 0.78
Tibia axial force - left (kN) 1.7
Tibia axial force - right (kN) 4.5
Foot acceleration (g)
Left 46
Right 95

How the moderate overlap front test is conducted

Side: original test

Rating applies to 2011-24 models

Tested vehicle: 2011 Mitsubishi Outlander Sport SE 4-door 4wd with standard front and rear head curtain airbags and standard front seat-mounted torso airbags

The Mitsubishi Outlander Sport was introduced in the 2011 model year. The vehicle is a variant of the Outlander SUV with a shorter overall length and no availability of a V6 engine or third row seats. Side ratings are assigned by the Institute based on a test conducted by Mitsubishi as part of side crash test verification.

Overall evaluation
Structure and safety cage
Driver injury measures
Head/neck
Torso
Pelvis/leg
Driver head protection
Rear passenger injury measures
Head/neck
Torso
Pelvis/leg
Rear passenger head protection
Technical measurements for this test

Measures of occupant compartment intrusion on driver side

Test ID VTS1009
B-pillar to longitudinal centerline of driver's seat (cm) -7.0
Negative numbers indicate the amount by which the crush stopped short of the seat centerline.

Driver injury measures

Test ID VTS1009
Head HIC-15 320
Neck
Tension (kN) 1.1
Compression (kN) 0.3
Shoulder
Lateral deflection (mm) 49
Lateral force (kN) 2.0
Torso
Maximum deflection (mm) 37
Average deflection (mm) 30
Maximum deflection rate (m/s) 4.98
Maximum viscous criterion (m/s) 0.40
Pelvis
Iliac force (kN) 2.5
Acetabulum force (kN) 2.6
Combined force (kN) 4.9
Left femur
L-M force (kN) 1.1
L-M moment (Nm) 139
A-P moment (Nm) 30

Passenger injury measures

Test ID VTS1009
Head HIC-15 287
Neck
Tension (kN) 0.3
Compression (kN) 0.3
Shoulder
Lateral deflection (mm) 36
Lateral force (kN) 1.7
Torso
Maximum deflection (mm) 28
Average deflection (mm) 22
Maximum deflection rate (m/s) 3.54
Maximum viscous criterion (m/s) 0.38
Pelvis
Iliac force (kN) 0.5
Acetabulum force (kN) 2.8
Combined force (kN) 2.8
Left femur
L-M force (kN) 1.1
L-M moment (Nm) 90
A-P moment (Nm) 41

How the side crash test is conducted

Roof strength

Rating applies to 2011-23 models

Tested vehicle: 2012 Mitsubishi Outlander Sport SE 4-door 4wd

Overall evaluation
Curb weight 3,294 lbs
Peak force 15,227 lbs
Strength-to-weight ratio 4.62

How the roof strength test is conducted

Head restraints & seats

Seat type: Manual cloth seats

Overall evaluation
Dynamic rating
Seat/head restraint geometry
Technical measurements for this test
Seat type Manual cloth seats
Geometry
Backset (mm) 36
Distance below top of head (mm) -10
Seat design parameters
Pass/fail Pass
Max T1 acceleration (g) 10.3
Head contact time (ms) 65
Force rating 1
Neck forces
Max neck shear force (N) 50
Max neck tension (N) 515

How the head restraint & seat test is conducted
Currently, IIHS tests apply only to front seats.

Front crash prevention: vehicle-to-vehicle

System details

  • Standard Forward Collision Mitigation with Pedestrian Detection

Overall evaluation

Applies to 2020-23 models

Superior
Superior
  • This system meets the requirements for forward collision warning.
  • In the 12 mph test, this vehicle avoided a collision.
  • In the 25 mph test, this vehicle avoided a collision.

How front crash prevention is evaluated

Child seat anchors

Rating applies to 2015-24 models

Overall evaluation
Vehicle trim SE
Seat type cloth

This vehicle has 2 rear seating positions with complete child seat attachment (LATCH) hardware.

It has 1 additional seating position with a tether anchor only.

Overall evaluation
Vehicle trim SE
Seat type cloth
1 2 3
G Good
A Acceptable
M Marginal
P Poor
Seating positions that rely on borrowed lower anchors or have only a tether anchor available are not rated.
thether anchor symbol
Tether anchor
lower anchor symbol
Lower anchors
shared lower achors symbol
Lower anchor(s) can be borrowed from adjacent positions(s)
No hardware available

Details by seating position

1
Tether anchor
easy-to-find location
other hardware could be confused for anchor
Lower anchors
not too deep in seat
not too much force needed to attach
easy to maneuver around anchors
2
Tether anchor
easy-to-find location
no other hardware could be confused for anchor
Lower anchors
none available
3
Tether anchor
easy-to-find location
other hardware could be confused for anchor
Lower anchors
not too deep in seat
not too much force needed to attach
easy to maneuver around anchors
Technical measurements for this test

Seat position 21

3

Lower anchor A
Open access rated No
Depth (cm) 0-2
Force (lbs) 13
Clearance angle (degrees) 70
Lower anchor B
Open access rated No
Depth (cm) 0-2
Force (lbs) 19
Clearance angle (degrees) 65
Tether anchor
Location Middle seatback
Confusing hardware present Yes
Has contrasting label
within 3 inches of tether anchor
No

Seat position 22

2

Lower anchor A
No lower latch for this seat position
Lower anchor B
No lower latch for this seat position
Tether anchor
Location Middle seatback
Confusing hardware present No
Has contrasting label
within 3 inches of tether anchor
Yes

Seat position 23

1

Lower anchor A
Open access rated No
Depth (cm) 0-2
Force (lbs) 11
Clearance angle (degrees) 67
Lower anchor B
Open access rated No
Depth (cm) 0-2
Force (lbs) 11
Clearance angle (degrees) 77
Tether anchor
Location Middle seatback
Confusing hardware present Yes
Has contrasting label
within 3 inches of tether anchor
No

How child seat anchors are evaluated

End of main content